How To Fix A Short Circuit Fuse

Sunday, February 2, 2014

How To Fix A Short Circuit Fuse

Follow these steps to restore power and get those appliances going again. The electrical panel is usually located in.

Vehicle Electrical Problems Blown Fuses Sun Auto Service

What Causes An Electrical Short Circuit

Wiring Grounding

Deal with the initial cause.

How to fix a short circuit fuse.

If you overload a circuit your system will cut off the electrical flow to prevent circuit damage or a fire.
The modern vehicle has several fuse boxes.
Now that you know what makes a fuse blow or circuit breaker.

Then there is also a fuse box that is for the body controls that is located under the dash.
This can be caused by an electrical component drawing to much current or a wire that touches a ground.
You can do this by unplugging all of your electrical devices that run on the circuit that keeps breaking.

Replace or repair a faulty switch fixture or wiring.
Install the adapter and breaker in the fuse box photo 1.
This means there is a short circuit in a light fixture or receptacle controlled by that switch or there is a short circuit in the switch wiring.

While dealing with electricity you need to be cautious.
Plug in one and reset the circuit breaker.
Continue to monitor the light on the tester and pull the vehicles fuses one by one until the light goes out.

Blowing a fuse or tripping a circuit breaker is a relatively common issue especially if you like to vacuum listen to music and microwave popcorn at the same time.
Determine which appliance has a short in it.
Reinstall the fuse and test the circuit.

Step by step procedure to fix a blown fuse step 1.
Move on to the next and check it using the same method.
Open the wiring harness and locate the chafed or shorted wires and repair them with electrical tape.

If one of them trips the circuit breaker or blows the fuse youve identified the source of the problem.
One is usually designated for the engine controls and is located under the hood.
Then find the short with the meter photo 2.

If the circuit breaker doesnt trip then that device is fine.
When the light goes out you have found the circuit that contains the short.
Trace the lines going to and leaving the fuse box for the circuit with the short.

Locate the electrical panel.