Step 3 checking the washers. Try tightening this nut with your hand then carefully tighten it a little more with a wrench.
If not move on the the next step.
How to fix a leaking toilet tank supply line.
If the leak stops you are done.
Once the waters been turned off flush the toilet to empty out the tank.
If you cant find one tighten the regular plastic nut in two stages.
At least i should say on this particular type and most types you dont so.
Heres our official advice.
If the line continues to leak you may need to replace a washer in the nut.
Turn the water supply valve behind the toilet clockwise to turn off the water supply.
Turn off the water supply at the shutoff valve located beneath the tank near the floor.
Flush the toilet and allow the water to escape from the tank.
Loosen the jamb nut with an adjustable wrench pull out the old ball cock and put in the replacement part.
Buy a toilet water 18 supply line that has a metal nut or a reinforced plastic compression nut.
Turn off the water and empty the water out of the tank.
There will be some.
We will work from the toilet back to the wall to locate the problem.
Use a dry rag and your finger to determine which spot is leaking.
Take care not to overtighten.
1 at the nut that connects the supply line to the fill valve.
If the leak on your toilet water supply line is coming from around the fitting it can usually be fixed by just tightening the fittings a little tighter.
First tighten it enough to stop the water from leaking.
You need shut the water off at the shut off valve.
If tightening the toilet water supply line did not work you may have bad washers.
Mop up any residual water with a sponge.
Turn the water back on and flush the toilet to test your work.
Toilet leak from under tank area duration.
The supply line itself also has a nut that attaches to the valve.
Locating toilet supply line leaks.
You dont have to drain all the water from the toilet tank because the fill valve is a one way valve.
Using your hand tighten the nut.
You can also use a cup or a shop vac to get the water out of the tank.
2 the nut that connects the supply line to the shut off valve.
The supply line nut.
Toilet leak from water supply line rafa dejesus maintenace guy.
You need to take your small pipe wrench place it on the fitting and very gently tighten the line.
How to fix a leaking toilet.
Then use a wrench to tighten the nut a bit more.
No comments:
Post a Comment