Position the hammer dolly on the outside of the dent and your body hammer on the inside. To repair minor dents in your car bodywork try using a plunger or dry ice.
Cool the heated metal.
How to fix a small dent in a car metal.
Most cars use a combination of metal and plastic to form the side panels and the bumpers.
For deeper dents on steel parts of your vehicle a more involved method using a dent repair kit might be necessary.
The hair dryer alone will not fix the issue.
Start by rubbing the edge of the plunger with a damp rag to moisten the suction surface.
Youll hammer against the dolly as it stabilizes the taps made inside the dented surface from the outside of the sheet metal.
To get to the back of the dented metal you need to remove door panels or fenders.
Then position the plunger over the dent and press the plunger towards your car.
Blast the dented area with compressed air and wait until the metal snaps back into place.
Fixing a shallow dent in your car is usually a straightforward process.
A plunger works well for large shallow dents in a door or the hood.
Turn the can upside down and spray until the liquid coats the area and it should pop into place.
You can attempt to hammer them out by placing a flat piece of metal with a rag wrapped around it to protect the paint from scratching on the outer side of the vehicle and banging the dent from the underside with a flat ended hammer.
Heat up the middle of the dent until it is too hot to touch or you start to smell plastic.
If you have small dents in a steel part.
Be very careful to bang only the underside of the dent and not the surrounding area or youll end up with a couple of new bumps to deal with.
Https Encrypted Tbn0 Gstatic Com Images Q Tbn 3aand9gcqpolel9zmnapodgjyltelx6m2cwhrvbxdisp1nr9u28u3v4rn0 Usqp Cau
Https Encrypted Tbn0 Gstatic Com Images Q Tbn 3aand9gcq0tj0cj8kl5vhbfipq0ghap4peie630wyy1k3un9z28ohzd3sx Usqp Cau
No comments:
Post a Comment